Garage door won't close: sensor repair in Mountainside

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (908) 540-6896

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Mountainside realigns or replaces the sensors and tests the safety reverse.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Mountainside

Nearly a third of Mountainside is parkland, most of it the Watchung Reservation, and houses on the reservation edge and the upper slopes live with leaves, acorns, deer and smaller wildlife. Driveways there are steep, and rain and meltwater run down to the garage, which often sits under a split-level or ranch. Around Mountain Avenue's center, mid-century homes have original brackets and brittle wire. On the Echo Lake Park side, low ground stays damp. Along Route 22, road grit and salt film the lenses in winter. Most houses here date from the 1950s and 60s, so many openers are on at least their second set of sensors.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Mountainside

  • Upper slopes: Higher streets with views and steep driveways.
  • Route 22 side: Southern streets near the highway with mid-century homes.

See the full Mountainside service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (908) 540-6896
Call (908) 540-6896